SLIONTEC Corporation

Home >> Products

Search by Product

Search by Application

Product List

No.636000

UV dicing tape: standard type

Slion Tape No. 636000 is a dicing tape formed by applying a UV release adhesive to a highly isotropic polyolefin base material.
This tape can firmly secure workpieces during dicing, and chips can be easily picked up through irradiation with UV light. This tape can be used for the dicing of a wide variety of wafers including silicon wafers, etc.

Tape structure

Applications

Dicing of a wide variety of wafers

Tape Performance

Test item		Unit	Value
Thickness	Tape thickness	μm	100
Thickness	Adhesive thickness	μm	10
Adhesion Figures in parentheses: after irradiating with UV light	To SUS plates	N/10mm	2.60 (0.16)
	To glass		2.70 (0.18)
	To silicone wafers		2.50 (0.15)
Holding power (40°C, 9.8N, 24 hours)		Deviation: mm	< 0.1
Tensile strength [TD/MD]		N/10mm	17/20
Elongation [TD/MD]		%	760/770

Test method: JIS Z 0237 (2000)
• Adhesion: Measured at 20 min after applying and pressing tape to each adherent using a 2 kg roller rolled back and forth once. 90° peel, pulling speed: 300 mm/min
• UV irradiation: High pressure mercury vapor lamp used. Irradiation was approximately 300 mJ/cm². (Intensity: approximately 75 mW/cm² x approximately 4 seconds at 365 nm)
• MD: Machine direction TD: transverse direction

Standard Dimensions and Units Per Package

Size (width × length)	Content per carton
230mm × 100m	4 rolls
300mm × 100m	4 rolls

Please consult us for other sizes.
Note) Content maybe changed without prior notice.

Directions for use


	(1)	When this tape is not in use do not leave it exposed to light as this degrades the adhesive properties of this product. Place this tape in a light-shielding bag and take care to prevent exposure to light as much as possible. In particular, exposure to sunlight and fluorescent lamps (insect attraction lamps, etc.) that contain strong ultraviolet light components degrades the adhesive properties of this product in a short period of time, and should be avoided.
	(2)	Defective peeling and adhesive deposits tend to occur at excessively high UV intensities, high irradiation doses, and at high temperatures. With regard to UV irradiation, avoid using this tape at intensities higher than 100 mW/cm² and irradiation doses exceeding 1000 mJ/cm².
	(3)	Bonding or pickup may become impossible depending on the adherend material, surface conditions, and the presence or absence of moisture or oil, etc. Consult us if you intend to use special applications and adherends. (TEL: 0120-147-224)
	(4)	Store this tape in a cool dark location and use by the expiration date.
	(5)	Avoid direct hand contact with the adhesive surface.
	(6)	When this tape is applied to incorrect locations and needs to be re-applied, use new tape.
	(7)	The figures shown in this catalogue were obtained through in-house tests we believe to be reliable, but the accuracy of these values is not guaranteed.
	(8)	All the contents shown in this catalogue are subject to change without notice.
	(9)	We assume no responsibility for any accidents caused as a result of using this product. Carry out thorough evaluations before deciding to use this product.

5484080207